16621
General Mach Discussion / Re: dro's no movint
« on: February 05, 2010, 05:57:49 PM »
If you MDI a X move does the Y DRO move?
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hood, you say that you have an AC servo for your spindle, how do you have that setup in Mach? I was going to go into that here, but it turned into a new topic, called "spindle encoder, VFD, rigid tap, lathe"
Thanks again all,
Dustin