Messages

661

VB and the development of wizards / Re: Set Position Automated Tool Height Sensor G06Start/end

« on: December 28, 2020, 01:16:47 AM »

try to put

Code: [Select]

While IsMoving
Wend

after each movement code

662

CS-Lab / Re: CSMIO IP-M Drivers alarm wiring

« on: December 27, 2020, 04:00:15 AM »

take a look here:

https://en.cs-lab.eu/csmioip-m-vs-wabeco-fvd-varicon/

the principle is the same.

663

General Mach Discussion / Re: sent my father in law a dxf and it isn't opening?

« on: December 23, 2020, 10:42:35 AM »

Does any of these open Mach 3  ''*.f3z, *.f3d, *.fbx, *.iam, *.ipt, *.obj, *.skp, *.smt, *.step, *.stl, *.stp''

no

664

General Mach Discussion / Re: sent my father in law a dxf and it isn't opening?

« on: December 23, 2020, 09:39:19 AM »

thats no g-code file that is a dxf file.

665

General Mach Discussion / Re: sent my father in law a dxf and it isn't opening?

« on: December 23, 2020, 09:00:41 AM »

open Notepad
filetype -> any file
search and open your file

666

General Mach Discussion / Re: sent my father in law a dxf and it isn't opening?

« on: December 23, 2020, 08:44:52 AM »

anyhow the file ending is not so important, but it must be a Textfile.

you can do a test, by opening with Notepad, then you should see the G-code you expect.

667

General Mach Discussion / Re: sent my father in law a dxf and it isn't opening?

« on: December 23, 2020, 08:35:31 AM »

for Mach3 Default is .tap can also be .txt

any testfile is ok.

668

General Mach Discussion / Re: Need help. Mach 3, ESS Smooth Stepper, Windows 10

« on: December 22, 2020, 02:05:42 AM »

if you use Standard 1024 screenset there is on the program run page (first tab) in the
middle bottom u button called Jog ON/OFF. is there a green Frame around the button?

next Thing is, witch Version did you install? there is a patched Version for Win10 avaliable.

669

General Mach Discussion / Re: mach3 turn spindle dro not working, spindle speed changing while jogging

« on: December 21, 2020, 04:04:53 AM »

try to run .062

if i have a look to the Mach3 Changelog

https://www.machsupport.com/wp-content/uploads/2013/04/Changelist90.txt

a lot of changes for threading have been made after .022

670

General Mach Discussion / Re: mach3 turn spindle dro not working, spindle speed changing while jogging

« on: December 21, 2020, 03:54:52 AM »

Config -> Port's&Pin's -> Turn Options -> X- Mode

do i realy have to explain the difference between Diameter and radius for a lathe user?