13111
General Mach Discussion / Re: incresing speed on stepper motors
« on: January 23, 2011, 11:39:27 AM »
My thoughts
Using a voltage nearer the 36 volts max of the drives should help a lot,
Setting to 8 microsteps should help smooth things out.
The power supply you are using is a bit on the neat side for current, would be better another amp at least I would say.
Screws with more pitch/starts would also help.
Hood
Using a voltage nearer the 36 volts max of the drives should help a lot,
Setting to 8 microsteps should help smooth things out.
The power supply you are using is a bit on the neat side for current, would be better another amp at least I would say.
Screws with more pitch/starts would also help.
Hood