31
General Mach Discussion / Re: Run Batch G-Code with hold between files
« on: October 25, 2020, 05:31:32 PM »
OK the easy way is to assemble all 120 files into 1 file with a M00 in between each section. You WOULD need to remove any M30 from the end of each file except for the end of the complete file.
Another way would be to program them as Subroutines calling each file in order and again adding a M00 at the end of each subroutine.
Another way is to try a Macro program that calls each file as an indivdual file in the order of run.
There can be quirks with each style. Things like IF you actually need to see the toolpath for each file.
Just a thought , (;-) TP
Another way would be to program them as Subroutines calling each file in order and again adding a M00 at the end of each subroutine.
Another way is to try a Macro program that calls each file as an indivdual file in the order of run.
There can be quirks with each style. Things like IF you actually need to see the toolpath for each file.
Just a thought , (;-) TP