Messages

3241

Works in progress / Re: About to abandon a screen set - Mach Blue

« on: April 09, 2006, 08:04:14 PM »

So Benny are you going to help him finish it ...

IF you guys need any VB send it to me and I will do it when I have time.

3242

General Mach Discussion / Re: WinCNC and Mach3 compatability

« on: April 09, 2006, 09:45:46 AM »

Do you have a pin out for there cables or any other info? If you do I can take a quick look at it...

3243

General Mach Discussion / Re: WinCNC and Mach3 compatability

« on: April 09, 2006, 09:08:14 AM »

It is a matter of preference... 

3244

General Mach Discussion / Re: Mach3 buttons

« on: April 08, 2006, 07:31:06 PM »

It was put in for the plasma people... But you may find some cool thinks to use it for

3245

Mach3 and G-Rex / Re: no ip on rex

« on: April 08, 2006, 06:20:07 PM »

okay that is starting to tell me that it is not even looking at your computer I am going to have Art look at this thread. Thanks

3246

Mach3 and G-Rex / Re: no ip on rex

« on: April 08, 2006, 05:54:03 PM »

go to a comand prompt and type ipconfig and tell me what you are getting for an IP. is it what you are getting from the Gloader

3247

General Mach Discussion / Re: Mach3 buttons

« on: April 08, 2006, 05:52:14 PM »

Pause = FeedHold
and Reverse is used to run the program in reverse... when you are running a Gcode program press feedhold and rather than pressing cycle start press the revers run button. the machine will go back over where it had come from.

3248

General Mach Discussion / Re: Denford ORAC.

« on: April 08, 2006, 05:49:47 PM »

with a little VB we can do the same with mach3...

3249

General Mach Discussion / Re: Denford ORAC.

« on: April 08, 2006, 03:44:52 PM »

You can use a PLC OR you can use a MOD IO card. I use PLC's but others have had great luck with the MOD IO... The PLC (DL06) can be programed to run on it's own so Mach woudl tell the tool number and the PLC would send back that it was done.

Hope that helps
Brian

3250

General Mach Discussion / Re: Just starting out.

« on: April 08, 2006, 03:42:44 PM »

Rust all you have to do is set the pins and you can run up to a 1000 line program You are not going to need limit switches to get up and running