Messages

1821

Feature Requests / Re: Safe Z on Feedhold

« on: December 23, 2006, 09:51:13 AM »

You could write the original position to a Var in mach3 and swhen you press resume you could have it move back to that position

Problem solved

1822

General Mach Discussion / Re: Arc Radius and cutter radius

« on: December 23, 2006, 09:14:07 AM »

The inside Rad must be greater then the tool rad, they can't be the same

1823

General Mach Discussion / Re: Help with Gecko's

« on: December 23, 2006, 09:12:51 AM »

It is a 5V common...  Not ground

Thanks
Brian

1824

Feature Requests / Re: Parametric Programming

« on: December 22, 2006, 08:59:24 PM »

Use the Force! (VB)

It is not as bad as you think... For example

Code"X" & Xpos & " Y" & Ypos

This will output a line of Gcode with whatever you have Xpos and Ypos set to

1825

VB and the development of wizards / Re: Yes/No or Ok/Cancel dialog

« on: December 22, 2006, 08:52:55 PM »

Love it Scott! It was not that long ago you didn't know how to do stuff like this and Now here you are telling others...
Grass Hoppa  You have come far!

1826

General Mach Discussion / Re: Stepper iregular or stalling in MDI or program run

« on: December 22, 2006, 08:36:07 PM »

Great, you should be cutting parts in no time

1827

General Mach Discussion / Re: FeedHold restart errors on ARC

« on: December 21, 2006, 11:39:46 PM »

The problem is a hard one to explane It has to do with looking at where you have been and where you are headed BUT without a road... Comp is NO fun (in the program that is)

Art is working on it and I have shown him this post

thanks

1828

General Mach Discussion / Re: Stepper rregular or stalling in MDI or program run

« on: December 21, 2006, 11:36:58 PM »

you should be running better then that... what do you have for axis settings?
Steps per unit?
Vel
and Accel

What mode are you running in? 25KHz?

thanks
Brian

1829

Show"N"Tell ( What you have made with your CNC machine.) / Re: Some wing molds out of mdf off of my big mill

« on: December 21, 2006, 11:33:29 PM »

You are not wrong, just less right  

How fast do you run that Mill? also I sent you a message off list on the board Chad

1830

Tangent Corner / Re: I was Dreaming of a white Christmas--- I got it!

« on: December 21, 2006, 11:13:34 PM »

In Maine we can take that I would have gone to work! (It is just down the hall) 

Looks like fun to me, I have a 55Hp John Deere that loves to move snow. I hope for it to snow at times so I can go out and run it! Programing makes you think all the time and running stuff like that is just FUN.

Enjoy