1
General Mach Discussion / homing and limit switches
« on: December 01, 2010, 01:18:57 PM »
I am trying to get my machine to be able to set the Machine Coordinates but I watched the videos and when I set the limit switches to active high and then go to diagnostics the yellow lights come on for them. The yellow lights will go out if I set the limit switches to active low only. Also my machine is a three axis and when I try to do a "reference all" and I hit the escape key the whole process stops it does not switch over to the x or y axis. the first one to move is my z axis. Any suggestions on these problems. I also notice that I do not have a limit switch on the z azis for it to hit when I go to zero for the reference only a switch at the bottom.
we will just start from here. When i bring my z axis to the top how can I make a change to zero it at that point so I can then let the machine zero the x and y azis
thanks
butch
we will just start from here. When i bring my z axis to the top how can I make a change to zero it at that point so I can then let the machine zero the x and y azis
thanks
butch