1891
General Mach Discussion / Re: question on weight
« on: September 12, 2013, 06:30:30 AM »
Attach the motor curve you are using.
RICH
RICH
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
So, would a tight machine stalling a motor cause this fuse to pop?The G201's are limited to 7 amps, the drive amp setting is determnined by the size of the resistor on the drive connections.
Another question, I am building a 4' X 3' machine. What size motors should I use if I plan to cut Aluminum ?Suggest you have a look at machines similar to what you are building. Post back when you have more specifics.