DICKEYBIRD,
Haven't used Doplhin lathe in a number of months here so starting to forget specifics.
Anyway.....
DOPLHIN TURNING POST PROCESSORS
Mach 3 - Radius mode: T_mach3Rcss
Mach 3 - Diameter mode: T_mach3DcssT
For version 10 and 11 I use the above post processors, but I mostly work in diameter mode and thus use
T_mach3DcssT and the code output for arc's are I k. I also have reversed arcs checked in my cofiguration.
Note the following changes for version 11:
As of Version 11 – a new section is required within all Lathe posts. This section must appear after the
Title section and must look like this :
VERSION:
FILEVERSION 11.0 TURNING
END
Dolphin worked for me for what I wanted to do. I plan on getting back into it in the near future.
Version 12? Well don't know if I will spend money to upgrade. After a while you get tired of the upgrade crap.
I wish i had the money i spent on AutoCad over the years as i would be able to pay someone to do the drafting!
Till then,
RICH