Messages

2371

Newfangled Solutions Mach3 Wizards / Re: Wizard Update Notifications?

« on: August 21, 2006, 07:13:09 AM »

2.70 and I think it was just minor bug fixes... I have been trying to think what more I can add... but it is working so good that I hate to break it

2372

G-Code, CAD, and CAM discussions / Re: Gibbs Cam

« on: August 21, 2006, 07:11:22 AM »

I think Gibbs is the only one that can write up a post for Mach3.. I don't know this for sure but I think that is the case... I Also think it is 500.00 for a can post.
So call your dealer and see what they can do for you

Sorry
Brian

2373

General Mach Discussion / Re: newflange "Unlicenced Wizard massage" .. help

« on: August 21, 2006, 07:08:53 AM »

There is a message that pops when you first press on the conversational button if you are not registered... I will have to think about that...

2374

General Mach Discussion / Re: Cannot wait to start !!!!

« on: August 20, 2006, 10:03:00 PM »

All the mills I have done have been 3000 Lb or more I am not one for the small mills... I think people use the small mills because they can have them at there house and in there house if they like! If i had one I would put it by the mixer    People seem to make many very nice parts with he small mills.. I think they just take lots of small cuts.

2375

G-Code, CAD, and CAM discussions / Re: Mach2 Emergency Stop

« on: August 19, 2006, 08:32:54 AM »

Sounds like you need to have a debounce value.. There is noise in your system and that is triggering your Estop Under State or Logic there is a place to put a debounce value. Try about 2000 or 1500

2376

General Mach Discussion / Re: g-rex spindle analog

« on: August 18, 2006, 09:00:15 PM »

You are starting to work like me now

2377

General Mach Discussion / Re: Interface bwteen the parallel ports and Servo motors

« on: August 18, 2006, 08:59:36 PM »

I don't know his number But any of the breakout boards ahould work.. you just need to have two of them you can set up a second port in Mach and it will use the same hardware

PMXD has a nice setup as well as cnc4pc

Hope that helps
Brian

2378

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 18, 2006, 04:41:03 PM »

You need to change your rapid height to something other then 0.. If you set your rapid height to .3 I think you will be happy

That should do it..

2379

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 18, 2006, 09:34:35 AM »

It is now in the new version on line Art just got the probe work that he was working on done so you have a new probe plugin and the new Lcam !

2380

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 18, 2006, 09:13:55 AM »

It is on the FTP server

This version with a few other fixes should be out tonight in the release