Messages

2301

General Mach Discussion / Re: Tool change location button

« on: September 02, 2006, 08:43:23 AM »

Just an FYI  you will need a new tool change macro to read the tool change pos from the DRO's. If you would like I can post a new tool change macro (there are many that have asked about this in the past few weeks)  and upload it to the FTP server.

Thanks
Brian

2302

General Mach Discussion / Re: Basic questions

« on: September 02, 2006, 08:39:53 AM »

1Ghz or better and it should be a desktop computer

There is a program called LazyCam that is free with Mach3 and will take in 2d DXF's

Hope that helps
Brian

2303

General Mach Discussion / Re: Those pesky circles

« on: September 02, 2006, 08:37:44 AM »

I think if you can post a pic of the inside of the control box we can tell you what you are running The guys here have installed and run about everything

2304

General Mach Discussion / Re: Those pesky circles

« on: August 31, 2006, 09:48:17 PM »

Could you please tell me what you are running for drives? Also what is your steps per unit...

2305

General Mach Discussion / Re: PID In MACIV

« on: August 31, 2006, 09:43:30 PM »

Yes it can be done but only if you are a C programmer and can make a plug In to run the device There is no simple way... sorry..

2306

General Mach Discussion / Re: Softlimits

« on: August 31, 2006, 09:36:20 PM »

Yes it is in the latest dev version of mach3 If it is going to go past the softlimits it will give you a message when you press the cycle start.. or it should

2307

General Mach Discussion / Re: Can you stop release on outside jogging

« on: August 31, 2006, 09:31:46 PM »

This is a known bug and we are looking into it now

Thanks
Brian

2308

General Mach Discussion / Re: New PlugIn just about done..

« on: August 31, 2006, 09:29:05 PM »

David you don't need any software for the shuttle on your computer So take it all off and I think it will start working right

2309

LazyCam (Beta) / Re: LazyCAM 2.56 MachManIP MFC Errors

« on: August 30, 2006, 09:31:38 PM »

I will have a look at it ... Thanks

2310

General Mach Discussion / Re: Some Simple Questions

« on: August 30, 2006, 09:28:24 PM »

Hood is a great guy and you are lucky to have him helping you. The toolcahnge position is not the int he stock tool change macro if you would like me to post a macro that uses it I can