18961
General Mach Discussion / Re: y axis
« on: June 06, 2009, 12:18:44 PM »
Swapping the drive out would be the first thing I would do, if the problem moves to the X then the drive is the problem.
Swapping the motors would be another thing to try but obviously nott such a quick swap.
Do you have a breakout board? Could be that it is the problem, maybe swapping pins for the Y would help also.
Hood
Swapping the motors would be another thing to try but obviously nott such a quick swap.
Do you have a breakout board? Could be that it is the problem, maybe swapping pins for the Y would help also.
Hood