6171
General Mach Discussion / Re: machine running irregular on button script
« on: December 15, 2010, 12:12:38 PM »
I see your point for engraving (no pun intended)
NOT sure the need for G68 probing (;-) It is VERY easy to rotate a part square to the table(;-) But each his own on that one(;-)
OK the solution is to RefALL to the same 0,0 point as your Fixture offset. That way it all reads and writes the same values(;-)
The machine corrds and users corrds will be exactly the same.
I wonder IF you could apply the surface offsets to the axis correction map or possible use the data to create an offset table of Gcode variables.
MAYBE a wizard to compile all the info into a gcode file???
Just trying to keep it simple and trouble free, (;-)TP
NOT sure the need for G68 probing (;-) It is VERY easy to rotate a part square to the table(;-) But each his own on that one(;-)
OK the solution is to RefALL to the same 0,0 point as your Fixture offset. That way it all reads and writes the same values(;-)
The machine corrds and users corrds will be exactly the same.
I wonder IF you could apply the surface offsets to the axis correction map or possible use the data to create an offset table of Gcode variables.
MAYBE a wizard to compile all the info into a gcode file???
Just trying to keep it simple and trouble free, (;-)TP