11
General Mach Discussion / Re: New PC Loosing Steps (I think)
« on: June 01, 2010, 12:55:48 PM »
Well after yet another clean install of XP and MACH my situation is no different.
I have had a plunge gauge in the Z axis and programmed some very fast moves ranging from 90mm right down to 0.1 mm and finshed off at Z zero and the dial gauge shows it is bang on, no signs of any missed steps at all.
It seems only to happen when all three axis are moving together!
Can anyone tell me what the "TIME IN INT" number means this is on the diagnostics screen just below "Jog ON/OFF control-alt-j" button as I have noticed the readout is jumping all over the place which might be ok I don't know?
Thanks for everyones help, this is now starting to drive me mad.
Andy
I have had a plunge gauge in the Z axis and programmed some very fast moves ranging from 90mm right down to 0.1 mm and finshed off at Z zero and the dial gauge shows it is bang on, no signs of any missed steps at all.
It seems only to happen when all three axis are moving together!
Can anyone tell me what the "TIME IN INT" number means this is on the diagnostics screen just below "Jog ON/OFF control-alt-j" button as I have noticed the readout is jumping all over the place which might be ok I don't know?
Thanks for everyones help, this is now starting to drive me mad.
Andy