611
Post Processors / Re: Fusion 360 / Autodesk Post Processors.
« on: January 10, 2021, 12:56:21 AM »
Perhaps re-trace your steps…
Go through the ESS laser set-up details here; https://www.warp9td.com/index.php/faq/faq-mach4#LaserSetup
And carefully check that you have completed each step correctly.
My original ESS / Mach4 laser test file is ‘Star Trek.tap’ located in the .zip file here; https://www.machsupport.com/forum/index.php?topic=18345.0
Run this Gcode and if you have set everything up according to the ESS set-up details then your laser will fire correctly.
Hope this helps.
Tweakie.
Go through the ESS laser set-up details here; https://www.warp9td.com/index.php/faq/faq-mach4#LaserSetup
And carefully check that you have completed each step correctly.
My original ESS / Mach4 laser test file is ‘Star Trek.tap’ located in the .zip file here; https://www.machsupport.com/forum/index.php?topic=18345.0
Run this Gcode and if you have set everything up according to the ESS set-up details then your laser will fire correctly.
Hope this helps.
Tweakie.