1
General Mach Discussion / RFH not working in Plasma
« on: December 03, 2016, 05:26:24 PM »
When I was having issues with the M31 faulting I tried to restart a file with a Run From Here. I use it all the time on my mills and lathe but on the plasma it just started moving right away and the code actually started from the beginning rather than stepping through until the RFH point was reached.
I have spent hours trying to work out why, evenmade a new profile from scratch and tested as I went.
Eventually I have found the issue. It seems if there is a macro called from the G Code which contains a G31 then the problem will happen.
Why it does that I have no idea and it is a bit of a PITA as it means I can not use RFH if I need to for any reason.
I think Set Next Line should work, it certainly seems to be fine in simulation but I will have to test out on the Plasma to be sure.
I have spent hours trying to work out why, evenmade a new profile from scratch and tested as I went.
Eventually I have found the issue. It seems if there is a macro called from the G Code which contains a G31 then the problem will happen.
Why it does that I have no idea and it is a bit of a PITA as it means I can not use RFH if I need to for any reason.
I think Set Next Line should work, it certainly seems to be fine in simulation but I will have to test out on the Plasma to be sure.