16711
General Mach Discussion / Re: Advanced Spindle Control
« on: January 29, 2010, 06:34:57 PM »
There used to be a board called the pixie that did that but its no longer made. I have heard Rutex do one but have not heard of anyone using one.
You would have to use SwapAxis() to change between spindle and axis depending on what you were wanting to do, ie positioning, rigid tapping etc you would swap spindle to A via macro, normal turning and threading you would swap back again.
Hood
You would have to use SwapAxis() to change between spindle and axis depending on what you were wanting to do, ie positioning, rigid tapping etc you would swap spindle to A via macro, normal turning and threading you would swap back again.
Hood