HELLO FRIENDS OF THE FORUM. I've adapted the MACH3 and I have made glass cutting table of 3300X2400mm.
Only cuters linear or parallel to the X axis and Y axis.
NOT BE AS MAKE THE RIMMED WHEEL CHANGE OF POSITION BEFORE MOVING ALONG THE SAME AXIS.
I mean for example to cut glass sheet 3000 X 2000
G0 X0Y0 ' HOME POSITION
G0 X3000Y0 ' SETTING FOR
G1 Z-4 ' LOW THE RIMMED WHEELS
G1 X3000Y2400 ' MAKES THE CUT ALONG THE Y AXIS (THE WHEELS THIS ANGLE IS 90 DEGREES )
G1 Z0 ' RISES RIMMED
G0 X3000Y2000 ' IS POSITIONED TO CUT
G1 Z-4 ' LOW RIMMED
G1 X0Y2000 ' makes the cut along the X axis (the wheel should be ANGLE IS 0 degree )
G1 Z0 ' RISES RIMMED
BRAIN CONTROL:
GOTO Y IF I= 0, active OUTPUT2 (ACTIVATES the solenoid valve that controls the angle 0, DEACTIVATED the angle is 90 degrees)
link:
http://www.youtube.com/watch?v=62ar3Kjt1K8