hello to everybody
just instaled mach3 and board tb6560. motors have no reaction on software. motors don't move. I allready have run drivertest. can u give me any suggestions?
Just visit the "Ports and Pins" section of Mach3 and configure the Pins used to drive things. I can help you with an XML file if you like, I just need to see a link to the board you have chosen to use.
For the "Red" TB6560 board found on ebay you would configure mach3 by setting the "X Enable" to 2, and "X Direction" to 3
"Y Enable is then 4, and Step is 5, and "Z enable" is 6 and Z direction is 7"
These pins change from board to board, it just depends on the manufacturer.
Pulses are sent threw the Pins as directed by your PC thanks to the Mach3 software, so if your choosing the wrong pin to send the signal to the stepper, no current is noticed by the stepper and nothing moves.
Hope this helps,
Rob
http://www.whatisacnc.com