2971
General Mach Discussion / Re: changing dro while running
« on: January 07, 2012, 07:01:28 AM »
Dosen't work here for the standard screen. Quick test here using the MDI ..... G01 Z-2 F.5 and tried increasing using the buttons but no go while the axis is in motion. That is different than using the mill screen for the lathe which will allow you to overide the feedrate.
May be able to change the screen though. Not sure if there would be problems if one did that .
RICH
May be able to change the screen though. Not sure if there would be problems if one did that .
RICH