3341
General Mach Discussion / Re: non coordinated move
« on: December 26, 2012, 04:52:29 PM »
No such thing in Mach3. Being YOUR Z runs in a mechanical loop MACh3 would not have any idea where it was in the loop.
To speeds things up you need to make sure the z does not move any further than it has to to drill the hole and clear the top of material. ( minimal movement time) Then speed up the axis accelleration speeds to as fast as they can accelerate and not loose steps. May need regearing to keep the steppers inside of the torque curve of the motor.
(;-) TP
To speeds things up you need to make sure the z does not move any further than it has to to drill the hole and clear the top of material. ( minimal movement time) Then speed up the axis accelleration speeds to as fast as they can accelerate and not loose steps. May need regearing to keep the steppers inside of the torque curve of the motor.
(;-) TP