3651
General Mach Discussion / Re: Gcode mishaps
« on: April 05, 2016, 02:19:15 AM »
Your Gcode is shambolic (to say the least) but it does work.
I am assuming…
1) Your Mach3 settings are such that a +Z command moves the tool away from the work and a –Z command moves the tool towards the work.
2) You are setting Z0.0000 as being the top surface of the work.
Is this the case ?
Tweakie.
I am assuming…
1) Your Mach3 settings are such that a +Z command moves the tool away from the work and a –Z command moves the tool towards the work.
2) You are setting Z0.0000 as being the top surface of the work.
Is this the case ?
Tweakie.