281
General Mach Discussion / Re: Rotator switch for Jog increments
« on: February 04, 2022, 01:26:40 AM »
if i look to this manual:
https://www.cnc4pc.com/pub/media/productattachments/files/c10r11.3_user_manual_ver.2.pdf
there is one jumper to set pin 2-9 as inputs and if you use 5V for the inputs the jumper need's to
set to Pull down and then the inputs must be Low active.
but if you have used pin 2/3/4/5 for step/dir sinals you can not use 7/8/9 for inputs.
https://www.cnc4pc.com/pub/media/productattachments/files/c10r11.3_user_manual_ver.2.pdf
there is one jumper to set pin 2-9 as inputs and if you use 5V for the inputs the jumper need's to
set to Pull down and then the inputs must be Low active.
but if you have used pin 2/3/4/5 for step/dir sinals you can not use 7/8/9 for inputs.