561
General Mach Discussion / Re: New computer
« on: February 26, 2021, 05:52:15 AM »
If you post your .xml file then your Mach3 settings can be checked and hopefully the problem found.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
So would I now set in output signals Output#2 - Port#2 & Pin#8
What do I set Output#1 to?
Hi Tweakie
Just so you know what I've done,
I have wired the both my Y axis motors to the Y axis outputs on the CP0-10V, Swapped the A+ & A- on the slave stepper motor, this has given me pin 8 & 9 free.
Is that wrong?
Allan