5321
General Mach Discussion / Re: Converting an existing commercial machine to use Mach3
« on: April 23, 2013, 01:38:55 PM »
What you need to do is find out the type of make/model of motors and drives/amplifiers then you will hopefully find info as to what kind of command signal they accept.
I would imagine, if it is a commercial machine, that it will use analogue command input, if that is the case then there are a few controllers out there that work with Mach and that can control analogue drives/amps.
One of them is the CSMIO/IP-S and I have just used that on a Chiron FZ12S VMC retrofit and I couldnt be happier with it
Hood
I would imagine, if it is a commercial machine, that it will use analogue command input, if that is the case then there are a few controllers out there that work with Mach and that can control analogue drives/amps.
One of them is the CSMIO/IP-S and I have just used that on a Chiron FZ12S VMC retrofit and I couldnt be happier with it
Hood