Hello everyone.
CADCAM uses FUSION360, but when generating the Tap file, I found the method by G84.
This method works with Mach4 Hobby.
The photo is FUSION 360.
However, the drawback of Mach4 is Feed Hold.
Mach3 is easier.
By all means, I want you to improve Mac4! !! !! !! !! !!
Is my understanding wrong? ?? ?? ??
*****************
For Mach4
1, Stop
2. Put a line in Line.
3, rotate the spindle.
4, Cycle Start
・ For Mach3
1, Feed Hold
2, designation of arbitrary line
3, Cycle Start