Starting to tune my table and I ran into an odd thing. I was setting up motor speed and other things and all was fine in mach 3 mill. I though I should do the same in mach 3 plasma I checked the pins for motor control and set the same speed values in motor control and then turned on jog to check. Well the X buttons moved the Z motor and Y motor was fine but Z buttons did nothing ( not able to move anything but the dro displayed movement). I just moved from mill to plasma software and nothing else was changed.
All motor pins are the same in both software settings.
I am using ver 2.58. have you seen this or heard of it???
Thanks
Tom