1
General Mach Discussion / Re: STEPCRAFT Plugin
« on: September 22, 2019, 08:12:11 AM »
You have right!
From Stoney the answer was that they have support but only for the machines bought from them!
Whatever!
I will tray to make a copy set-up from UCCNC but I thought there are someone on the forum which is using stepcraft with UC100 and Mach3 and can help me!
From Stoney the answer was that they have support but only for the machines bought from them!
Whatever!
I will tray to make a copy set-up from UCCNC but I thought there are someone on the forum which is using stepcraft with UC100 and Mach3 and can help me!