1
Mach4 General Discussion / Mach 4 Wont save Configuration
« on: October 14, 2021, 10:20:50 PM »
I have just installed Mach 4 with an ess, that went well on Windows 10.
I am currently trying to configure the software, but I have run into a show stopper. When I go into say, Config/Outputs, I enable Outputs 1-3 to be an ESS Port 1 pins P2, P3, and P4. I hit apply, and OK.
When I go back into the settings screen, the outputs show no configuration. The enable checkmarks remain, but the port and pin configuration is gone.
This happens on Inputs, Outputs, and several other screens. I found nothing about it in the dox
HELP!
I am currently trying to configure the software, but I have run into a show stopper. When I go into say, Config/Outputs, I enable Outputs 1-3 to be an ESS Port 1 pins P2, P3, and P4. I hit apply, and OK.
When I go back into the settings screen, the outputs show no configuration. The enable checkmarks remain, but the port and pin configuration is gone.
This happens on Inputs, Outputs, and several other screens. I found nothing about it in the dox
HELP!