Messages

1871

General Mach Discussion / Re: Scripter Compile Error bites again :(

« on: March 24, 2018, 06:47:48 AM »

Hi Thank you for the reply,

if i use M84 my System allways get stuck.

1872

General Mach Discussion / Re: Scripter Compile Error bites again :(

« on: March 24, 2018, 05:52:29 AM »

hello Dave,

you wrote that you are using rigid tapping
with cs lab enc module?

in G84 or with M84 ?

Thomas

1873

General Mach Discussion / Re: Only X-axis motor is working

« on: March 24, 2018, 03:20:24 AM »

can you post your new XML

1874

SmoothStepper USB / Re: SMOOTH STEPPER SAVED FILES

« on: March 23, 2018, 05:59:16 PM »

Hello Frank,

at least it not such a "big deal" to create a new Profile.

the old one is not "lost".

here:

http://www.kd-dietz.com/klausphp/pages/eng/machprofile/description/m_profile_description.html

is a realy (IMHO) good free software  to few  Profile data

1875

General Mach Discussion / Re: Servio motor Delta adas b2 Software and electronic gear ratio

« on: March 23, 2018, 05:52:29 PM »

i personaly agry with Craig.

we are on the wrong side of searchihg the fault.

the servo drive is absolutlty doinig what it's suposed to do.

the problem is the the controler.

1876

General Mach Discussion / Re: Mach3 wont fire torch on plasma table

« on: March 23, 2018, 02:12:36 PM »

glad to hear that it working now.

1877

General Mach Discussion / Re: Mach3 wont fire torch on plasma table

« on: March 23, 2018, 02:11:18 PM »

exactly

please edit both files


M3.m1s should contain a DoSpinCW()
M3.m1s should contain a DoSpinStop()

1878

General Mach Discussion / Re: Mach3 wont fire torch on plasma table

« on: March 23, 2018, 01:47:12 PM »

sorry i was wrong.

there should be a Folder

 C:\mach3\macros\your Profile Name ?

"your Profile Name" should be displayed on main scree right bottom side (Profile).

1879

General Mach Discussion / Re: Mach3 wont fire torch on plasma table

« on: March 23, 2018, 12:55:03 PM »

ok then we know all the Hardware is working, witch is good.

can you please post a copy off your M3.M1s and M5.M1s maco,
witch is located in C:\mach3\your Profile Name\macros ?

thank you

i know it's allways hard to troubleshoot from far away

1880

General Mach Discussion / Re: Mach3 wont fire torch on plasma table

« on: March 23, 2018, 12:37:38 PM »

ok thank you.
Setup is clear now.

Torch on is on port2 pin1.

i assume when you click Torch ON button (1) on your Screen
-torch ON LED (2) is comming up
-torch ON LED (3) on your TC301 is not comming up ?