1381
General Mach Discussion / Re: OEM codes for buttons, DRO's and LED's
« on: February 28, 2019, 12:50:14 PM »
just type in the number, not all of them are in the pull down list.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
there is no way to put a password on your screenset
You can only protect your macros by saving them as precompiled (*.mcc).
SetTriggerMacro(301)
If IsActive (OEMTRIG1) Then
Code("M whaeveryouwhant")
End If