Messages

3291

General Mach Discussion / Re: Mach 2 freezing right after loading my profile

« on: April 03, 2006, 01:53:52 PM »

Did you turn anything on in Mach3?

3292

General Mach Discussion / Re: Hermes Vanguard 6000 engraver

« on: April 02, 2006, 08:30:56 PM »

Nice looking rig!

3293

General Mach Discussion / Re: Manufacture PCB

« on: April 02, 2006, 08:28:26 PM »

After looking at the code I think I can make a VB converter or I can make it a part of LazyCam

3294

General Mach Discussion / Re: Need help configuring axis please

« on: April 02, 2006, 06:54:50 PM »

I get 40598.9 steps per unit...

3295

General Mach Discussion / Re: Manufacture PCB

« on: April 02, 2006, 06:49:36 PM »

Is this just for drilling? If so send me a file and I will see if it can be done...

3296

General Mach Discussion / Re: Getting New Installation Going

« on: April 02, 2006, 05:42:16 PM »

You didn't uncheck the "install Driver" on install did you???

3297

General Mach Discussion / Re: WinCNC and Mach3 compatability

« on: April 02, 2006, 05:40:54 PM »

WinCNC is doing the same job as Mach3 ... The old Ford Chevy thing...

3298

General Mach Discussion / Re: Wrong way "Z"

« on: April 02, 2006, 05:39:54 PM »

To change the Axis Direction go under ports/pins / motor output and change the Dir pin active high state for that axis and you should be good to go...

What type of moptors are you running?
Thanks
Brian

3299

General Mach Discussion / Re: Hermes Vanguard 6000 engraver

« on: April 02, 2006, 05:35:04 PM »

Do you have the pinout for it??? I think you will find that it is a COM port and is not for running the drives... I think your best bet is going to be putting on new drives.

3300

General Mach Discussion / Re: Can Mach3 be run in constant velocity and backlash comp. together?

« on: April 01, 2006, 05:30:22 AM »

I don't think it has been worked on ..