13471
General Mach Discussion / Re: Can't get the spindle/pulley calibration figured out
« on: January 01, 2011, 08:02:56 PM »
Ok well the manual seems to say set to max velocity with a step per at 1000 but it doesnt explain much more from what I could see, so might be best going back to that.
I think Mach should output whatever you have in the spindle pulley as a max but from your earlier tests it didnt seem to do that.
Might be best contacting Arturo to see if he can advise how to set up his board.
Hood
I think Mach should output whatever you have in the spindle pulley as a max but from your earlier tests it didnt seem to do that.
Might be best contacting Arturo to see if he can advise how to set up his board.
Hood