1801
General Mach Discussion / Re: Help a noob to wire up Mach3 USB board
« on: October 10, 2018, 08:13:29 AM »
Excellent
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Their knowledge is not that much honestly.. that's why I'm posting here
The version I am running is R3.042.037.
Is the a more resent version if so were do I down load it and do I have to pay?
Can you please tell me why do we not get meaningful readings when using continuous mode on a powered up circuit?
@Tweakie: Measuring it the old fashioned way using continuous mode on dmm.