6601
Show"N"Tell ( Your Machines) / Re: The Laser Project.
« on: August 15, 2011, 04:19:20 AM »
Hi Amir,
I use 5mm pitch ballscrews and my maximum, 100% reliable, G0 and laser feedrate is 4,500mm/min.
I doubt belt drive would improve my machine speed because of the mass of my combined X and Z axis but a purpose built machine could perhaps exceed 20,000mm/min without too much effort.
Tweakie.
I use 5mm pitch ballscrews and my maximum, 100% reliable, G0 and laser feedrate is 4,500mm/min.
I doubt belt drive would improve my machine speed because of the mass of my combined X and Z axis but a purpose built machine could perhaps exceed 20,000mm/min without too much effort.
Tweakie.