4551
General Mach Discussion / Re: Setting Inch or Metric -- GCode only????
« on: June 22, 2010, 09:35:31 PM »
Is there a screen set going about that has one?
Someday! Don't know when, but, seems they are getting along with mill, so maybe turn will get it's turn.
There was a thread which asked what the new turn screens should be like some time ago.
RICH
Someday! Don't know when, but, seems they are getting along with mill, so maybe turn will get it's turn.
There was a thread which asked what the new turn screens should be like some time ago.
RICH