5
« on: May 26, 2009, 06:50:41 AM »
I got my router powered up for the first time yesterday and everything went good till I got to the Y axis motor tuning. I can only get the y Axis to drive in the plus direction on the table. I verified the setup in Mach, tested the motor on another driver (it ran both directions), moved the control wires to another controller and the problem followed, and I have an led indication on the board that I am getting a signal from Mach. The board is a CNC4PC C11G. Everything came from Keling and he has been very helpful and I have an email into CNC4PC. Is there anything in mach to help with further diagnosis? It all seems to point to the board.
Thanks
Jimmy