5411
General Mach Discussion / Re: Licensed Mach 3 Stopped mid project.
« on: March 04, 2013, 12:21:52 PM »
Hi Josh,
Welcome to the forum.
Try turning off the toolpath display (just above the Reset in the Diagnostics window) before you run any long programs.
(I think the problem may relate to graphics card capabilities but turning off toolpath display usually works).
Tweakie.
Welcome to the forum.
Try turning off the toolpath display (just above the Reset in the Diagnostics window) before you run any long programs.
(I think the problem may relate to graphics card capabilities but turning off toolpath display usually works).
Tweakie.