Messages

1971

LazyCam (Beta) / Re: Pimp my Lcam

« on: November 19, 2006, 11:01:32 AM »

You can set how that layers are made by changing the optimize settings. after you load the file press the optimize button and  you should be good to go:)


The tool change has been fixed along with the Drilling


thanks
Brian

1972

General Mach Discussion / Re: Multipass button

« on: November 19, 2006, 10:43:14 AM »

There is a multi pass wizard that works much better then the old way of doing it

1973

General Mach Discussion / Re: single block problems

« on: November 19, 2006, 10:42:00 AM »

There was a bug with single block and it was fixed in the 2.00 Rev

Please update

Thanks

1974

General Mach Discussion / Re: New CV features

« on: November 19, 2006, 10:39:32 AM »

It is the time to accel the axis that is the problem With an accel of 15.00 In/Sec^2 it takes .666 sec to get to 600 In/Min.. That is a VERY long time.. Now to blend the moves there is the problem of rounding the corners and so on.. the lowwer the accel the more rounding you are going to get.

What do you have your CV Dist set to?

thanks
Brian

1975

General Mach Discussion / Re: slow stepping on power up

« on: November 19, 2006, 10:31:47 AM »

To run the driver test open the Mach3 directory and look for Drivertest.exe and run only that. You can't run mach3 and the driver test at the same time.

thanks
Brian

1976

General Mach Discussion / Re: Load Mach3 to Laptop

« on: November 19, 2006, 10:29:58 AM »

run the Driver test on the laptop and tell me what you see for a graph.

thanks
Brian

1977

General Mach Discussion / Re: profiles quest

« on: November 19, 2006, 10:28:44 AM »

The XML should be saved when you close Mach3 and that will save where the screen set you are using is... So it will not load the screen set when you start the program?

1978

LazyCam (Beta) / Re: inf lazycam 2.64 mach3 rc2.0.g

« on: November 18, 2006, 08:20:07 AM »

Okay that is two of you with the same problem I still can't get it to happen here! That makes it very hard to fix... I think that I will have to recode that section and see if i fix it by luck..

1979

General Mach Discussion / Re: Rapids

« on: November 18, 2006, 08:17:50 AM »

What are your accel settings for each axis?

1980

General Mach Discussion / Re: Changing init line

« on: November 18, 2006, 08:05:23 AM »

You will have to edit the VB code in the wizard set... This is not that hard al you need to do is press the Edit button script and press on the one that you would like to edit.

Look for something like      CODE "G00 G80 G40 G50 " and change it to whatever you like. Once you change it save the code and close the VB editor and then you need to save the screen set.