12401
General Mach Discussion / Re: Will only run part of G-code program
« on: March 04, 2011, 06:27:28 AM »
It will depend what MAXNC gave you, if they just bundled Mach with it then chances are they were not selling you a licence as part of the deal, however if it was meant to be a licenced version then likely you would have had an email with a file called Mach1Lic.dat. If you find it just place it in the Mach3 folder and start Mach and you should be good to go.
If you were not sold the licence as part of the deal then you will have to buy one if you want the full version.
Hood
If you were not sold the licence as part of the deal then you will have to buy one if you want the full version.
Hood