I hope I am posting this in the correct section of the forum.
I have a question about moving around the work piece and running different G codes.
I will try to explain but I may be trying to do something that is not practical.
Example:
G code #1 starts at 0,0 and cuts a rectangle that is 2"X4"
I have a work piece that is 12" square in the machine and the starting point is located at the center of the piece with the DROs at 0,0
I run code #1 at this location and when finished I want to move to another location and run this code again. In other words I want to cut many rectangles out out this piece with out loosing my original location of 0,0 and not having to change the G code.
Thank you
Ray