Messages

881

General Mach Discussion / Re: Mach3 add on help

« on: July 31, 2007, 03:17:12 PM »

Dan I can tell you that you had Emailed me in the past on

7/13/07 12:32PM
7/13/07 2:58PM
7/24/07
7/30/07

aslo I left a message on your phone.. I called with in about 30 min of the time that you asked. I am sorry but there is not much more that I can do at this time. If you would like I gave you my number in the message and will be happy to help you.

Thanks
Brian

882

General Mach Discussion / Re: Spindle relay

« on: July 31, 2007, 03:09:58 PM »

Hello,
'What pin do you have the output set to? You can check this under outputs (also be sure that the port is set)

Thanks
Brian

883

General Mach Discussion / Re: THC 300 JERKS OR DOES NOT WORK?

« on: July 31, 2007, 03:07:25 PM »

Hello, did you contact the guys that you got the THC from?

Thanks
Brian

884

Mach3 and G-Rex / Re: G100 crashing?

« on: July 30, 2007, 05:39:43 PM »

Also I have had this problem in the past.... what do you have for network connections? Do you have more then one network setup on that computer? Do you have it plugged in where there is a router that is not liking the IP range? I have found that I have to turn off all other networks on the Host computer to get the device to upload the firmware.... Please try a few things and als know that it takes time to make things better and we are here to help you (I feel your pain)


Thanks
Brian

885

Mach3 and G-Rex / Re: G100 crashing?

« on: July 30, 2007, 05:28:12 PM »

I have sent this to Steve (the firmware guy for the G100) we will see what he thinks about his and if he can get it working for you.

Thanks
Brian

886

General Mach Discussion / Re: Continuous jog mode

« on: July 29, 2007, 03:49:16 PM »

Will it work if you press and hold the Shift Key and press the arrow key?

887

General Mach Discussion / Re: e stop schematic

« on: July 25, 2007, 06:58:16 PM »

What are up running for a breakout board??? If you look at the docs for the breakout board you will find what they would like to have for an Estop.
Thanks
Brian

888

General Mach Discussion / Re: We need Linux port

« on: July 25, 2007, 06:56:03 PM »

Yup and we will never have a linux port... Time is the problem and I just don't see more then about 10 people that would use Linux... I would rather take the time to add the 3rd order planner!

889

General Mach Discussion / Re: Controle panel simplified DX1

« on: July 25, 2007, 06:46:34 PM »

Cool...

890

General Mach Discussion / Re: Rectangle & circle part error

« on: July 25, 2007, 06:45:32 PM »

You need to tell me a bit more about your machine and what you were doing...

What is the  Accel of the X and Y axis? What Vel were you trying to cut the circle? could you please post the code that you were doing to cut a circle?


Thanks
Brian