Messages

2771

LazyCam (Beta) / Re: trouble with 2.53

« on: June 16, 2006, 09:18:06 AM »

Thank you for the info! I will look into the tool number problem that you are having

2772

General Mach Discussion / Re: Mirror image when engraving, why?

« on: June 15, 2006, 07:26:50 PM »

Good job getting that fixed! nice to see that you kept working on it!

2773

General Mach Discussion / Re: loops and nested loops. Can I use my bridgeport programs?

« on: June 15, 2006, 07:25:02 PM »

Are you talking about looping a Sub? If so it is the Q number that sets the number of times it is run

2774

Mach3 and G-Rex / Re: I'm ready are you! I/O Questions.

« on: June 15, 2006, 11:23:30 AM »

I think that the axis just needs to be enabled... So (I think) you can just take the pin numbers out

2775

General Mach Discussion / Re: Wizard editing......Possible?

« on: June 15, 2006, 11:21:49 AM »

I don't know much about that wizard Art made it some time ago... Post a section of code from the wizard and we will work on it together

2776

Newfangled Solutions Mach3 Wizards / Re: Wizard suggestions -

« on: June 15, 2006, 11:19:40 AM »

That is a good idea to add that to the Circular pocket

Pitch is used because it is the amount that it is going to drop per pass around the part and the Ramp angle is the angle that it is going to go into the part..

2777

LazyCam (Beta) / Re: trouble with 2.53

« on: June 15, 2006, 07:15:41 AM »

Use the middle mouse button to turn the view  and I will have a look at the file.

2778

General Mach Discussion / Re: Wizard editing......Possible?

« on: June 15, 2006, 07:12:24 AM »

What is the V2 wizard? I think we can take few lines out

2779

General Mach Discussion / Re: Help conecting mach3 with Automation Direct servo motors

« on: June 15, 2006, 07:10:41 AM »

I have been out for about a day and a half so i have not had time to look through the paper work at the shop (What a mess that is...). I should haveit by the end of the day

2780

General Mach Discussion / Re: Help a newbie!

« on: June 15, 2006, 07:07:38 AM »

This sounds like you may have missed steps in the Z axis..Check your max Velocity and Acceleration, I think you may have over driven your Z axis