Messages

2391

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 17, 2006, 09:12:27 AM »

There is also a new rev on the FTP server

Please have a look and see if that fixes your trouble.. If you geys are happy I will start to finisha few other things that I am working on...

Thank you
Brian

2392

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 17, 2006, 08:42:43 AM »

Other then the power going out for a bit this was fun ot fix The new Post processor is making it SO much faster to make changes with out beaking other things in the program.. I changed the default post in Lcam but I know you are not running a plasma so you can change the post to make your water jet run  If you have trouble I will give you a hand
Brian

2393

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 17, 2006, 07:58:09 AM »

Chip I am going to change the post so you can cut points. You will not be able to use the can cycle because I don't think you can have M3's and M5's in a can cycle

I should have this fixed in a few

2394

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 17, 2006, 07:55:00 AM »

If you hava a negitive depth it seems to be working well..

Chip i am now off to see what I can do to get you fixed

2395

LazyCam (Beta) / Re: New Lcam with post processor

« on: August 16, 2006, 10:13:48 PM »

The depth needs to be set to a negitive number I needed to add Positive cut heights for an OEM

Looking at the other stuff now

2396

General Mach Discussion / Re: dual processor

« on: August 16, 2006, 10:07:40 PM »

it should work ... But I have never tested it

2397

General Mach Discussion / Re: Tracing eye and mach

« on: August 16, 2006, 10:06:36 PM »

If you are a C programer You may be able to get it to work with a plug in... Other then that I don't think so

2398

General Mach Discussion / Re: Initial feed rate

« on: August 16, 2006, 06:47:42 AM »

Feed and Jog are not the same

Here is how you can change each one
To set the feed put an F(whatever you like) into the Init String on the Config Settings page

and to change the slow jog rate press Tab and you will get a fly out with all the jog settings.. there is a slow jog %, change that till you are happy

2399

General Mach Discussion / Re: Mach 3 looses position co-ordinates turned off.

« on: August 15, 2006, 09:18:07 PM »

There are some settings on the Config/Settings page that you can use to make it work like that.. Sorry I am rusty on how you have to set the settings But it is in the manual and if you run into to much trouble tell me and I will give you a hand

2400

General Mach Discussion / Re: scaling different axes for different speeds.

« on: August 15, 2006, 09:12:56 PM »

Yup, set the Rad of the part on the Settings page