Messages

1741

General Mach Discussion / Re: New CV features

« on: January 09, 2007, 07:06:58 PM »

Kree,
To get the FRO to not change the rapid rate please check the box that Is in the pic. You need to know that if you are doing long moves the FRO is going to take longer to work...
What are you running for a table?? I have an idea that it is a table like a shopbot and you should try the test version of Quantum and tell me if it makes your machine run a bit better... you will need to put in a value of about 1000 in the Jerk amount under path smoothing. Also you will have to double you accelerations...

BTW I know who you are now and I can tell you that quantum will fix the problem as I used your old test file to check quantum

Hope that  helps
Brian

1742

General Mach Discussion / Re: Mach 3 & Milling Spindle Control.

« on: January 09, 2007, 06:58:49 PM »

I have used the spindle speed board from Bob and I know cnc4pc has one...

1743

General Mach Discussion / Re: Strange G81 Operation in 2.031

« on: January 09, 2007, 06:57:33 PM »

It could have been a bug that Art fixed... there was a bug reported and I can't think what the heck it was! Just be sure that it is not wrong in .33! If it is please post there is a problem and we will get it fixed!

Thanks

1744

General Mach Discussion / Re: Screw mapping

« on: January 09, 2007, 06:58:03 AM »

Talked to Art and he told me that you need to put the position that the table SHOULD... Hope that helps

If you post on the yahoo group there may be a few others over there that can help Very sorry I don't know that section....

1745

General Mach Discussion / Re: Rotational feedrate problem

« on: January 09, 2007, 06:55:58 AM »

Nice! I will still have to have a look at the XML and see if there is a way to get that workign better

1746

Show"N"Tell ( Your Machines) / Re: Eagle KM-750..Anilam Crusader GX-M

« on: January 08, 2007, 01:09:58 PM »

Your setup is much like the one that I have on my eagle I have a DL06 with an analog card running the VFD.

1747

General Mach Discussion / Re: Rotational feedrate problem

« on: January 08, 2007, 01:08:12 PM »

I need you to do the following...

In MDI do a G01 Z.1 A 360 F80

then do a

G01 Z1.0 A.1 F80

and last G01 A360 F80

Tell me if you get an over speed on them.

Thanks

1748

General Mach Discussion / Re: Rotational feedrate problem

« on: January 08, 2007, 09:30:34 AM »

Cool that will tell me where to look in the code... that is a section of code that had not been worked on in a ver long time...

1749

General Mach Discussion / Re: Rotational feedrate problem

« on: January 08, 2007, 08:32:42 AM »

So is it the A only moves that are the trouble ?

1750

Mach3 and G-Rex / Re: G100 Limit Inputs in MACH3

« on: January 08, 2007, 08:18:40 AM »

We will work on docs when the new firmware comes out and the device is working to the point that we are happy with it... The doc's are a long hard job