761
General Mach Discussion / Re: M10/M11 Control
« on: September 26, 2020, 05:45:18 AM »
It varies depending on the motion controller being used but…
The command M11P1 turns ON Output#1 and the command M10P1 turns OFF Output #1 (the P number refers to the Output# number)
The Port and Pin of the Output# is defined and Enabled in Config / Ports and Pins / Output Signals.
The M11Px / M10Px commands must always be followed by an axis (any axis) move for them to take effect.
You will need to be using the latest Mach3 version.
Hope this helps,
Tweakie.
The command M11P1 turns ON Output#1 and the command M10P1 turns OFF Output #1 (the P number refers to the Output# number)
The Port and Pin of the Output# is defined and Enabled in Config / Ports and Pins / Output Signals.
The M11Px / M10Px commands must always be followed by an axis (any axis) move for them to take effect.
You will need to be using the latest Mach3 version.
Hope this helps,
Tweakie.