1881
Third party software and hardware support forums. / Re: Setting up mist control problems
« on: August 21, 2018, 09:54:08 AM »
Hi John,
The 0x278 is just a default and you would be right using 0xec00 for Port #2.
In Config. / Ports & Pins / Spindle Setup - Enable Flood Mist Relays and set the desired Output#'s for M7 and M8 (1 to 6).
In Config. / Ports & Pins / Output Signals - Enable & set the desired Port (2) and Pin Numbers (17) for the Output#'s used above.
Hope this helps,
Tweakie.
The 0x278 is just a default and you would be right using 0xec00 for Port #2.
In Config. / Ports & Pins / Spindle Setup - Enable Flood Mist Relays and set the desired Output#'s for M7 and M8 (1 to 6).
In Config. / Ports & Pins / Output Signals - Enable & set the desired Port (2) and Pin Numbers (17) for the Output#'s used above.
Hope this helps,
Tweakie.