1
Mach4 General Discussion / ERROR " E stop due to limit switch" while im cutting in mach 4
« on: November 10, 2018, 03:26:12 PM »
while cutting i get this message, " E stop Due To Limit Switch"
1 i have changed my limit switch wires to shielded, i grounded the shielding to earth ground,
2 i am using individual limit switches on each axis
3 they have there own pins in pokeys 57 cnc
4 im using a pokeys 57cnc break out board with maximum filter input, i also tried dropping the filter but it had no change other than maby worse,....
I have read somebody used capacitors on theres but they didnt explain how to or what to use really,...any info on this method would be appreciated
1 i have changed my limit switch wires to shielded, i grounded the shielding to earth ground,
2 i am using individual limit switches on each axis
3 they have there own pins in pokeys 57 cnc
4 im using a pokeys 57cnc break out board with maximum filter input, i also tried dropping the filter but it had no change other than maby worse,....
I have read somebody used capacitors on theres but they didnt explain how to or what to use really,...any info on this method would be appreciated