7181
General Mach Discussion / Re: exact stop vs cv mode
« on: October 12, 2012, 04:20:02 PM »
Can you attach your xml please and I will see if there is an issue in your config.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
The X axis, under repeated manual actuation (left/left/left) will intermittently change direction. Likewise manually actuating in the right direction multiple times the stepper intermitently reverses direction. Changing around motor leads moves the problem around.Are you meanng when you jog the axis via the keyboard it usually works fine but occasionally will go the wrong way?