2621
General Mach Discussion / Re: V Carving Quality - possible problem on entry and exit points?
« on: July 31, 2017, 02:39:02 AM »
Hi Steve,
That machining certainly looks like a great improvement on your earlier example. I think you are heading in the right direction.
A Z axis backlash of 0.0035" is not bad but V-Carving can place a lot of loading on the cutter so the whole machine really does need to be rigid. Have you tried taking a second pass at the work (same settings) ?
Tweakie.
That machining certainly looks like a great improvement on your earlier example. I think you are heading in the right direction.
A Z axis backlash of 0.0035" is not bad but V-Carving can place a lot of loading on the cutter so the whole machine really does need to be rigid. Have you tried taking a second pass at the work (same settings) ?
Tweakie.